How to Mount and True Diamond Wheels & CBN Wheels – Alredy in FAQs
Mounting: Flanges, plates and spindles should be clean, free of burrs and run true. Maximum run-out should not exceed .005” for…
How Do I Dress Diamond and CBN Wheels – Already in FAQs
Dressing:
To dress the wheel, select a dressing stick one or two grit sizes finer than the abrasive In the diamond or CBN wheel. Turn off the coolant pump.
Turn on the machine and allow the grinding wheel to reach full RPM, and then turn off the spindle motor. Apply the dressing stick to the abrasive section on the wheel with medium to light pressure until the wheel stops rotating.
Repeat the above step until the dressing stick feels like it is being pulled or drawn into the wheel. This may need to be repeated up to four or five times depending on the condition of the wheel surface.
Warning:
DO NOT USE CLUSTER OR SINGLE POINT DIAMOND DRESSING TOOLS FOR TRUING DIAMOND OR CBN WHEELS.
YOU MAY ALSO BE INTERESTED IN:
Typical Diamond Wheel and CBN Wheel Speeds – Already in FAQs
Typical Diamond Wheel and CBN Wheel Speeds Wheel Diameter RPM Range 3″ …