Dressing:
|
To dress the
wheel, select a dressing stick one or two grit sizes
finer than the abrasive
In the diamond or CBN wheel.
Turn off the coolant pump.
Turn on the machine and allow the grinding wheel to
reach full RPM, and then turn off
the spindle motor.
Apply the dressing stick to the abrasive section on the
wheel with medium to light
pressure until the wheel stops rotating.
Repeat the above step until the dressing stick feels
like it is being pulled or drawn into
the wheel. This may need to be repeated up to four or
five times depending on the
condition of the wheel surface.
|
