1) Select a
dressing stick
one or two grit
sizes finer than
the abrasive in
the diamond or CBN wheel.
2) Turn off the
coolant pump.
3) Turn on the
machine and
allow the
grinding wheel
to reach full
RPM, and then turn off the spindle motor.
4) Apply the
dressing stick
to the abrasive
section on the
wheel with
medium to light pressure until the wheel stops rotating.
5) Repeat the
above step until
the dressing
stick feels like
it is being
pulled or drawn into the wheel. This may need to be repeated
up to
four or five times depending on the condition of the wheel
surface.
|
